Differences in clock signal arrival times across the chip are called clock skew. It is a fundamental design principle that timing must satisfy register setup and hold time requirements. Both data propagation delay and clock skew are parts of these calculations. Clocking sequentially-adjacent registers on the same edge of a high-skew clock can potentially cause timing violations or even functional failures.
Below Figure 1 shows an example of sequentially-adjacent registers, where a local routing resource has been used to route the clock signal. In this situation, a noticeable clock skew is likely.
In Figure 1, all registers are clocked at the same edge, but the arrival time of the edge is different at each register. Figure 2 indicates an example of the clock skew for the circuit shown in Figure 1.
No comments:
Post a Comment
Please provide valuable comments and suggestions for our motivation. Feel free to write down any query if you have regarding this post.